Laying click tiles is easy and requires just a few steps. The tiles can be laid on a flat surface. The click system allows the tiles to snap seamlessly into place, which makes laying particularly time-saving.

Yes, defective or damaged click tiles can be replaced relatively easily. The click system allows a single tile to be removed without affecting the surrounding tiles. In this way, the floor remains visually appealing and functional.

By using a jigsaw or circular saw, the click tiles can be easily cut to size. The edges can then be smoothed with fine sandpaper.

To allow the material to easily expand with changes in temperature, we recommend planning a distance from fixed structures such as walls and other obstacles. An expansion joint of 1% of the total length and at least 2 cm width should be taken into account.

The maintenance of click tiles is uncomplicated. Regular sweeping or vacuuming keeps the floor clean. A damp wipe with a mild cleaning agent is usually sufficient for cleaning. However, avoid using harsh chemicals or harsh cleaning agents to avoid damaging the surface.

Depending on where the side panels are needed, different side panels must be used.
If you place the side parts completely around the entire thing, you will need half of the side parts with the sleeve and the other half without the sleeve.
When laying the cable, usually at the entrance or gate, side panels with a sleeve for the front are required.
If you want to be sure, you can check this again with our configurator or contact us.

Yes, our click tiles can be laid even if the floor is slightly uneven.

Even when the click tiles are wet, they remain slip-resistant.

Our click tiles can support loads of up to 9 tons per square meter. Our floor tiles are also shatterproof.