Installing click tiles is easy and only requires a few steps. The click system allows the tiles to snap into place seamlessly yet robustly, making installation particularly time-saving.

Yes, our click tiles are relatively easy to remove. The click system allows you to remove a single tile without having to remove the surrounding tiles.

The click tiles can be easily cut to size using a jigsaw or circular saw.

Plastics expand when heated, so we recommend that you allow a distance from solid components such as walls and other obstacles. An expansion joint of at least 1.5 cm should be planned.

Care for click tiles is uncomplicated. Regular sweeping or vacuuming keeps the surface clean. A damp wipe with mild cleaning agents is usually sufficient for cleaning.

Depending on where the side panels are needed, different side panels must be used.
If you place the side parts completely around the entire thing, you will need half of the side parts with the sleeve and the other half without the sleeve.
When laying the cable, usually at the entrance or gate, side panels with a sleeve for the front are required.
If you want to be sure, you can check this again with our configurator or contact us.

Yes, our click tiles can be laid even if the floor is slightly uneven.

Even when the click tiles are wet, they remain slip-resistant.

Our click tiles can support loads of up to 9 tons per square meter. Our floor tiles are also shatterproof.